Dakota Digital STR6D Instrukcja Obsługi

650066 1 VACUUM FLUORESCENT DIGITAL DASHBOARD SERIES 3 The latest in digital dashboard technology for the street rodder

650066 10 To enter DEMO mode, press and hold the switch while turning the key on. MESSAGE DISPLAYS On systems with two message dis

650066 11

650066 12 GAUGE SYSTEM FEATURES Mileage readings • Million mile odometer • Re-settable trip mileage (0-999.9) • Re-settable serv

650066 13 Setting up the control box SETUP MENU Main Menu Sub Menu DESCRIPTION .

650066 14 SPEEDOMETER SETUP Press and hold SW 1 switch, then turn the key on and start the engine. Once the engine is running, rel

650066 15 Press and hold the switch until “DONE” is displayed. Sender type Menu Empty R Full R GM 0-30 ohm GM 30 0 ohms 30 ohms GM

650066 16 Press and hold the switch until “DONE” is displayed. Display update setup When “UPDATE” is displayed press and release the

650066 17 Press and hold SW 1 until the desired night brightness is shown. When the system reaches its lowest brightness it will st

650066 18 Symptom Possible Problem Solution ------------------------------------------------------------------------------

650066 19 Symptom Possible Problem Solution ------------------------------------------------------------------------------

650066 2 Thank you for purchasing the Vacuum Fluorescent Digital Dashboard from DAKOTA DIGITAL, the leader in custom automotive el

650066 20 CLOCK Wiring instructions for VFD systems with a clock built in. Introduction: The clock displays the current time in 12

650066 3 WARNING The vacuum fluorescent displays are made of glass and should be handled with care. Use extreme care around the gl

650066 4 55-56 Chevy car chrome bezel shown with lens and display opening outlines. Next, take the supplied lens, with the lette

650066 5 Never connect this to a battery charger alone. It needs to have a 12 volt battery connected to it. Battery chargers have

650066 6 TACH Depending on the type of system that you have there may be a bar graph tachometer, a digital tachometer, or both. Co

650066 7 OIL The oil pressure sender included with this system must be used. Other senders will cause incorrect readings. If the

650066 8 CHECK The check engine terminal is used with fuel injection ECM’s to display engine problems and trouble codes. The CHECK

650066 9 The LEFT terminal is activated by a 12 volt signal from the turn signal switch. When this terminal has 12 volts, an arrow